Why is my terminal console showing -bash on mac

#WHY IS MY TERMINAL CONSOLE SHOWING BASH ON MAC INSTALL#
#WHY IS MY TERMINAL CONSOLE SHOWING BASH ON MAC SERIAL#

Note that slot 1 is reserved for the onboard NIC whether or not it is present.ДЇigure 3.1 Vertical slot and port numberingДЇor the 2U platform, slot numbering is top-to-bottom and port numbering is left-to-right as shown in Figure 3.2. As shown in Figure 3.1, for the 4U platform, slot numbering is left-to-right, and port numbering is top-to-bottom. where s is the slot number of the NIC, and p is the port number on the NIC. Before performing configuration tasks such as displaying interface status and settings, setting the media type, and setting the duplex mode, it is helpful to understand interface naming conventions.Д«y convention, the Ethernet interfaces on a BIG-IP system take the name. Examples of elements you configure as part of the high-level network are: Pools, rules, proxies, and network address translation (SNATs and NATs).ДЄ BIG-IP system can have as few as two network interfaces, and as many as twenty-nine. Once you have configured the base network, you can configure the high-level network. These features can be configured using either the Configuration utility or the bigpipe command.

#WHY IS MY TERMINAL CONSOLE SHOWING BASH ON MAC INSTALL#

Typically you would install a sniffer device on the target port for debugging and/or monitoring. This allows you to copy traffic from any interface or set of interfaces on a BIG-IP system Application Switch to a single, separate interface. STP domains provide for loop resolution in configurations where one or more external switches is connected in parallel with an IP Application Switch. If one link in a trunk goes down, traffic is simply redistributed over the remaining links. The other benefit of link aggregation is link fail-over. In link aggregation, interfaces can be combined into a trunk to increase bandwidth in an additive manner. If the BIG-IP system is an IP Application Switch, you also have three other BIG-IP system features you can configure:

#WHY IS MY TERMINAL CONSOLE SHOWING BASH ON MAC SERIAL#

You can add a serial terminal in addition to the console, or you can add a serial terminal as the console. You can configure a default route, as well as dynamic routing, DNS, and email. For example, you can insert host names for the IP addresses that you will assign to virtual servers, and host names for standard devices such as your routers, network interface cards, and servers.Д¬onfiguring an SSH console gives you the ability to use a command line interface to securely manage your local BIG-IP system. You can insert additional host names and IP addresses for network devices into the /etc/hosts file. You can change self IP addresses or create any number of additional self IP addresses for a VLAN. In addition, you can group separate VLANs together for the purpose of bridging packets between them. VLAN options include tagging and assigning interfaces to VLANs. You can set the media type and the duplex mode for an interface, as well as display interface status. You can perform these tasks using either the Configuration utility or the bigpipe command.Д®lements you might want to further configure after running Setup are: This chapter provides the information you need to perform these additional configuration tasks. Once you have configured the base network elements with the Setup utility, you might want to further enhance the configuration of these elements. For information on using the Setup utility, see Chapter 2, Using the Setup Utility. Configuration tasks for the BIG-IP base network are performed using the BIG-IP Setup utility. Setting up the base network for the BIG-IP system means configuring elements such as the BIG-IP system host name, a default gateway pool, interface media settings, and VLANs and self IP addresses.

Using a serial terminal with the BIG-IP system.

Why is my terminal console showing -bash on mac